Search:

Type: Posts; User: denman

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. You are welcome. The info on the following...

    You are welcome.

    The info on the following link may be useful to you.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4Nb0pXTTlDcGlXUWs
  2. Below is a link to a service manual for this...

    Below is a link to a service manual for this unit.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NTkozZ1AzbDFtZ1E

    It is "Electric Slide-In Range JES..."

    First I would unplug the unit and...
  3. You will have to open it up and check. My...

    You will have to open it up and check.

    My guess is that the idler wheel was squeaking and finaly seized.
    This then broke the belt.

    So now the broken belt switch is not activated (open) and...
  4. I am not sure why you think the roller has too...

    I am not sure why you think the roller has too much friction.

    There are thousands of these out there and this is the first time I have seen this complaint other than old units where the...
  5. Replies
    2
    Views
    70

    The following has a service manual...

    The following has a service manual
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NZWhXOVFPaXJ0a0U

    31-9162 GE PFSS6NKW... should be a close match to your unit
  6. Replies
    1
    Views
    60

    Do you have the tech sheet? I cannot find it so...

    Do you have the tech sheet?
    I cannot find it so can only give general info.

    Check the heater circuit at the control board with a meter.
    This will ensure that the heater, thermostat and wiring...
  7. Replies
    3
    Views
    96

    I am assuming that you have the tech sheet/wiring...

    I am assuming that you have the tech sheet/wiring diagram.

    With the dryer running measure across the heater relay contacts at the control board (should be a red wire and a black wire)

    On air...
  8. Replies
    5
    Views
    92

    I cannot say so just check them. If they are...

    I cannot say so just check them.
    If they are closed when the door is latched then probably the control board is bad.
  9. Replies
    5
    Views
    92

    The diagnostics are on page 2 f the wiring...

    The diagnostics are on page 2 f the wiring diagram (Water/Service Test)

    Both switches are on the latch assembly in the door
  10. Replies
    4
    Views
    91

    You are probably just reading the meter wrong. If...

    You are probably just reading the meter wrong. If you are on the 20K scale or higher the meter does read out in kiloms.

    Without a wiring diagram I cannot say if the interior light is controlled by...
  11. Replies
    5
    Views
    92

    Below is tech info on this unit....

    Below is tech info on this unit.
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=fghd2433kf1&User=&Search=Search

    Try running he diagnostics.
    With a meter check that both door switches...
  12. Replies
    4
    Views
    91

    I cannot find any tech info on this unit or...

    I cannot find any tech info on this unit or specific info on a Hc error code.

    It could be that you need a new board but I would check other things first.
    Check that the heating coil is in the 8...
  13. Below is a link to service info on this unit...

    Below is a link to service info on this unit
    https://drive.google.com/drive/folders/0BzIiBNwRIV4Nb0pXTTlDcGlXUWs

    Can you restart the unit right away?

    In not it could be that the motor is over...
  14. Replies
    1
    Views
    168

    Below is a link to service info on this unit....

    Below is a link to service info on this unit.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NSlhIYnJkLUg3Q2c

    You could try removing power from the unit for 10 minutes or so before doing any...
  15. Below is a link to a service manual "16010312...

    Below is a link to a service manual "16010312 Jenn-Air Elect..." which includes this unit.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NTkozZ1AzbDFtZ1E

    All I can suggest is that you double...
  16. Below is from the operators manual for this...

    Below is from the operators manual for this series.

    START/CANCEL
    To start a cycle, close the door and press
    the START/Cancel pad once. To cancel
    when a cycle is running, press the
    ...
  17. Thread: Help

    by denman
    Replies
    3
    Views
    166

    Sorry to confirm bad news. I hate seeing fridges...

    Sorry to confirm bad news.
    I hate seeing fridges bite the dust especially Beer Fridges.

    FYI When moving old units be as gentle as possible keeping them upright.
    Also plug them in as soon as you...
  18. Thread: Help

    by denman
    Replies
    3
    Views
    166

    is the compressor running? You should be able to...

    is the compressor running?
    You should be able to feel it vibrating and it will be warm.

    If it is running then you have a sealed system problem,
    It will be an expensive repair as you will need a...
  19. Replies
    1
    Views
    83

    You will need a multimeter and some knowledge on...

    You will need a multimeter and some knowledge on how to use it.

    First check the power.
    Otherwise you could rip the unit apart, spend hours on it only tofind out it is a power problem.

    Try...
  20. Replies
    5
    Views
    123

    This is a long shot but check the door seal. ...

    This is a long shot but check the door seal.

    It should be the same thickness as the freezer door.
    Also check the hinge side of the seal to be sure that it is not grabbing and twisting when you...
  21. Replies
    2
    Views
    305

    Below is a link to service manuals...

    Below is a link to service manuals
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NNXdidFJ6SHRPVzg

    I do not have a Cabrio manual for your unit but one of the Cabrio manuals in the link should...
  22. Replies
    3
    Views
    103

    Sounds good. When you do get a chance to run...

    Sounds good.

    When you do get a chance to run it I would recommend you try different heat settings just to check that the unit actually does regulate the heat.
  23. Replies
    3
    Views
    103

    The thermal fuse is blown. I would also check...

    The thermal fuse is blown.

    I would also check that the heater element is not grounded.

    If it is OK then I would also replace the hi-limit thermostat.
    The thermal fuse is a backup (safety...
  24. Replies
    7
    Views
    219

    I tried to attach it here but it is too big. ...

    I tried to attach it here but it is too big.

    Below is the tech sheet I mentioned.
    You may have to join the site to download it....
  25. Replies
    7
    Views
    219

    Do you have the tech sheet? It is often taped...

    Do you have the tech sheet?

    It is often taped to the back of the kick panel.
Results 1 to 25 of 498
Page 1 of 20 1 2 3 4