Search:

Can you please test your heating element for a short using the instructions at 2:25 in the video below and let me know what you find? It would leave the dryer unplugged and stop using it until you...

That's too bad. Did you replace the part with a new GE part? Have you verified that the water supply from the house to the washer is good? Are you using washer fill hoses with a burst valve in...

Hi CMV, we have a note on this part on our website. It says this: This DC motor has an electrical plug with a 3 pin harness. If you need the DC motor with a 4 pin harness order part number...

The next thing I would do is a voltage test at the LED lights. Check a working light to see what the voltage should be for a working light. Then compare that against what the voltage is to the...

It's probably not part of the dishwasher.

The H2O Supply error code would indicate that water is not entering the washer. If the water supply to the washer is good, it is usually caused by a bad water inlet valve. The water inlet valve for...

That's too bad they sold you the wrong part. Let me know how it works once you get the correct LP conversion kit installed.

Yes, the Variable Speed Wash Motor they are referring to in the tech sheet would be the Circulation Pump Motor. Below is a link to the part.

I would also check the wiring from the pump motor to...

Thanks for sharing what you found! I have updated this to FIXED. Although re-soldering that spot on the control board will usually get it working, it isn't something that I would recommend doing as...

Does the dryer heat up on the air dry (no heat) cycle?

These are really tricky belts to install unless you have done them a few times. I am glad you got it figured out!

It looks like the LP Conversion Kit for your model that I linked below should have included orifices to convert the oven burners. Is this the part that you used to convert the range?

LP...

You would have to test the reed switch with a magnet to trigger the switch and a multimeter to test the switch for continuity.

https://www.youtube.com/watch?v=F76qOqyYOqY

Beside the main control board, it could also be a bad temperature sensor on the evaporator coil. See the videos below. Please note that a temp sensor can test good but still be bad. Let me know...

I would try replacing the thermistor on the evaporator coil next. Sometimes they can fail even if they test good. If it isn't that, then it would come down to the main control board or the wiring...

Hi C!

It sounds and looks to me like the motor is failing and on it's last leg. I would replace the motor before it does and you lose any food. Let me know what you find.

This is the motor...

Thank you. Let me know how it goes for you.

Can you please list the error code that you are receiving?

I can tell from your video that the gearcase is bad and leaking which is why you have all of the brown residue on the bottom. It looks to me like you will need to replace the gearcase. Let me know...

Since your model washer is the exact model shown in our video, the steps should match up exactly. Do all of the buttons on your washer respond? Why are you doing a reset on the machine?

...

Sorry, I do not know what that component is.

Thank you for sharing. I have updated this to fixed.

This video might be helpful too:

https://www.youtube.com/watch?v=yMm91uA-KUY

Can you please post a picture of what has failed?

The Heavy light flashing typically indicates one of two things. 1. The high water float switch in on for 5 seconds in 5 times (Samsung's wording not mine). 2. The high water float switch is on for...

Sometimes the new door gaskets can take some time to break in and seal properly.