Search:

Type: Posts; User: denman

Page 1 of 13 1 2 3 4

Search: Search took 0.10 seconds.

  1. Yes I would come to the same conclusion that you...

    Yes I would come to the same conclusion that you did.

    If you can get some numbers off the relay you may be able to find one on the net and just replace it.
  2. I am assuming that you have already checked for...

    I am assuming that you have already checked for 240 volts at the terminal strip in the unit.
    If not that is the first thing I would do.
    Just checking for the two 120 volts is not good enough as you...
  3. Check to see if the door is sealing OK now....

    Check to see if the door is sealing OK now.
    Perhaps it is not and escaping hot air is heating up the door.
    This is probably OK.

    Remove the door from the unit.
    Place it with outside down on a...
  4. Replies
    1
    Views
    19

    I am assuming that you have the tech sheet ...

    I am assuming that you have the tech sheet

    Your current problem sounds like you need a new motor re: the centrifugal switches on it not activating
    One of the switches connects in the heater so...
  5. Replies
    1
    Views
    20

    I would let the ice melt off and then dry that...

    I would let the ice melt off and then dry that area.

    Then plug the unit in and see what happens.
    The compressor should come on.
    After about 10 minutes or so you should see a fairly even frost...
  6. Replies
    1
    Views
    14

    Since the noise increases when you open the door...

    Since the noise increases when you open the door odds are that it is the evaporator/freezer fan.
    https://partsdr.com/part/4389144-evaporator-fan-motor

    Also this would be a good time to...
  7. Could I bypass the thermister? No, you cannot...

    Could I bypass the thermister?
    No, you cannot bypass the thermistor as that is what is regulating your heat.

    How did you check it for open?
    You would have to have used the 200K or higher...
  8. Replies
    2
    Views
    27

    I'm getting 120v on both terminals with the dryer...

    I'm getting 120v on both terminals with the dryer running
    This does not really tell you anything.
    With the dryer running.
    If the relay closes you will see 120 and all is good re: L1
    If the relay...
  9. Below is info on this unit....

    Below is info on this unit.
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=+FEFL68GMA&User=&Search=Search

    First thing is to check the power.

    Try flipping the breaker off/on slowly...
  10. Sounds more like an electrical problem since...

    Sounds more like an electrical problem since unplugging it stops the water leak.

    You will have to check for voltage across the valves when the unit is plugged in but off.
    Check for both AC and DC...
  11. Thread: cabinet seals

    by denman
    Replies
    2
    Views
    125

    Does the below include the seals you are...

    Does the below include the seals you are referring to?
    https://partsdr.com/part/4172127-lower-door-seal-kit
  12. I cannot find any info on the given model number....

    I cannot find any info on the given model number.
    Please check it.

    Problem is likley the dispenser itself.
    Also could be a control board problem.
  13. Replies
    2
    Views
    175

    See the attachment for a wiring diagram....

    See the attachment for a wiring diagram.
    Although it is shown as a 6LE5700 it should be close or the same as your unit

    First double check the vent holes at the back of the drum and the lint...
  14. Replies
    3
    Views
    183

    I would check the unit with a level just to be...

    I would check the unit with a level just to be sure that it is level.

    It may be that a spring is bad.
  15. It still sounds like a house wiring problem to...

    It still sounds like a house wiring problem to me.

    For a couple reasons.

    1. Since one side of the line drops to zero when the unit is turned on, the only way this can happen is if there is a...
  16. Replies
    3
    Views
    183

    The following info and video should help....

    The following info and video should help.
    http://www.appliancepartspros.com/whirlpool-ring-sound-deadening-wp63134-ap6010158.html

    As far as the banging could be that the unit just needs...
  17. Replies
    1
    Views
    101

    Could also be the control board. May even be the...

    Could also be the control board.
    May even be the thermistor
    But the damper assembly is the most likely culprit
  18. Thank you for getting back to us. Sounds like...

    Thank you for getting back to us.
    Sounds like you have found the problem now all that is left is finding the bad part in the house wiring.
    I have seen this type of problem in the past but it is...
  19. Replies
    2
    Views
    149

    The following manual should help (2012 GE...

    The following manual should help (2012 GE Dishwasher) (31-9336 GE...)

    https://drive.google.com/drive/folders/0BzIiBNwRIV4NV1ZxdzBFRkNmUEE

    The TCO is shown in the Component Locator Section -...
  20. I think the 5 in the model number should be an S...

    I think the 5 in the model number should be an S

    Below is info on this unit
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=PLEs389ACA&User=&Search=Search

    Yes you can fix it...
  21. Below is info on this unit...

    Below is info on this unit
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NWWZET29FMzFablE

    All I can suggest is that you start over diagnosing the problem.

    Start with the voltage to the...
  22. Replies
    1
    Views
    112

    Below is a link to info for this unit....

    Below is a link to info for this unit.
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=+LGEF3045KFK&User=&Search=Search

    Your oven sensor looks OK.

    Just checking for voltage in the...
  23. I do not remember exactly what I sent. But...

    I do not remember exactly what I sent.

    But reading the post it was probably a tech sheet or a service manual so I need your model number.

    I will then see if I can find either for tour unit
    ...
  24. It could be the steering diode, see below. It...

    It could be the steering diode, see below.

    It is usually built into the valve wiring harness and the diode is usually covered with heat shrink.

    https://www.youtube.com/watch?v=tLIFLBGcvvI
  25. Below is info on this unit...

    Below is info on this unit
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=lfef3017lwd&User=&Search=Search

    Since the oven and the elements are separate from each other it is probably a...
Results 1 to 25 of 317
Page 1 of 13 1 2 3 4