Search:

Type: Posts; User: denman

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    25

    Do you have the tech sheet? I cannot find it so...

    Do you have the tech sheet?
    I cannot find it so can only give general info.

    Check the heater circuit at the control board with a meter.
    This will ensure that the heater, thermostat and wiring...
  2. Replies
    2
    Views
    52

    I am assuming that you have the tech sheet/wiring...

    I am assuming that you have the tech sheet/wiring diagram.

    With the dryer running measure across the heater relay contacts at the control board (should be a red wire and a black wire)

    On air...
  3. Replies
    5
    Views
    56

    I cannot say so just check them. If they are...

    I cannot say so just check them.
    If they are closed when the door is latched then probably the control board is bad.
  4. Replies
    5
    Views
    56

    The diagnostics are on page 2 f the wiring...

    The diagnostics are on page 2 f the wiring diagram (Water/Service Test)

    Both switches are on the latch assembly in the door
  5. Replies
    4
    Views
    54

    You are probably just reading the meter wrong. If...

    You are probably just reading the meter wrong. If you are on the 20K scale or higher the meter does read out in kiloms.

    Without a wiring diagram I cannot say if the interior light is controlled by...
  6. Replies
    5
    Views
    56

    Below is tech info on this unit....

    Below is tech info on this unit.
    http://b2b.frigidaire.com/support/ResultsPage.asp?strModel=fghd2433kf1&User=&Search=Search

    Try running he diagnostics.
    With a meter check that both door switches...
  7. Replies
    4
    Views
    54

    I cannot find any tech info on this unit or...

    I cannot find any tech info on this unit or specific info on a Hc error code.

    It could be that you need a new board but I would check other things first.
    Check that the heating coil is in the 8...
  8. Below is a link to service info on this unit...

    Below is a link to service info on this unit
    https://drive.google.com/drive/folders/0BzIiBNwRIV4Nb0pXTTlDcGlXUWs

    Can you restart the unit right away?

    In not it could be that the motor is over...
  9. Replies
    1
    Views
    99

    Below is a link to service info on this unit....

    Below is a link to service info on this unit.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NSlhIYnJkLUg3Q2c

    You could try removing power from the unit for 10 minutes or so before doing any...
  10. Below is a link to a service manual "16010312...

    Below is a link to a service manual "16010312 Jenn-Air Elect..." which includes this unit.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NTkozZ1AzbDFtZ1E

    All I can suggest is that you double...
  11. Below is from the operators manual for this...

    Below is from the operators manual for this series.

    START/CANCEL
    To start a cycle, close the door and press
    the START/Cancel pad once. To cancel
    when a cycle is running, press the
    ...
  12. Thread: Help

    by denman
    Replies
    3
    Views
    99

    Sorry to confirm bad news. I hate seeing fridges...

    Sorry to confirm bad news.
    I hate seeing fridges bite the dust especially Beer Fridges.

    FYI When moving old units be as gentle as possible keeping them upright.
    Also plug them in as soon as you...
  13. Thread: Help

    by denman
    Replies
    3
    Views
    99

    is the compressor running? You should be able to...

    is the compressor running?
    You should be able to feel it vibrating and it will be warm.

    If it is running then you have a sealed system problem,
    It will be an expensive repair as you will need a...
  14. Replies
    1
    Views
    67

    You will need a multimeter and some knowledge on...

    You will need a multimeter and some knowledge on how to use it.

    First check the power.
    Otherwise you could rip the unit apart, spend hours on it only tofind out it is a power problem.

    Try...
  15. Replies
    5
    Views
    113

    This is a long shot but check the door seal. ...

    This is a long shot but check the door seal.

    It should be the same thickness as the freezer door.
    Also check the hinge side of the seal to be sure that it is not grabbing and twisting when you...
  16. Replies
    2
    Views
    241

    Below is a link to service manuals...

    Below is a link to service manuals
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NNXdidFJ6SHRPVzg

    I do not have a Cabrio manual for your unit but one of the Cabrio manuals in the link should...
  17. Replies
    3
    Views
    91

    Sounds good. When you do get a chance to run...

    Sounds good.

    When you do get a chance to run it I would recommend you try different heat settings just to check that the unit actually does regulate the heat.
  18. Replies
    3
    Views
    91

    The thermal fuse is blown. I would also check...

    The thermal fuse is blown.

    I would also check that the heater element is not grounded.

    If it is OK then I would also replace the hi-limit thermostat.
    The thermal fuse is a backup (safety...
  19. Replies
    7
    Views
    186

    I tried to attach it here but it is too big. ...

    I tried to attach it here but it is too big.

    Below is the tech sheet I mentioned.
    You may have to join the site to download it....
  20. Replies
    7
    Views
    186

    Do you have the tech sheet? It is often taped...

    Do you have the tech sheet?

    It is often taped to the back of the kick panel.
  21. Replies
    7
    Views
    186

    I think you have one too many 7's in your model...

    I think you have one too many 7's in your model number.

    Yes it could solve this problem but you cannot be 100% sure unless you actually check the keypad outputs with a meter.
    Unfortunately the...
  22. Replies
    1
    Views
    81

    It sounds to me like your main board went bad....

    It sounds to me like your main board went bad.
    Why did you replace it?
    The first thing I would do is unplug the unit and disconnect reconnect all plugs at the main board, also carefully inspect...
  23. Replies
    3
    Views
    94

    OK the above still applies. I would also check...

    OK the above still applies.

    I would also check that the blower wheel is clean and that it is not slipping on the motor's shaft.
  24. Replies
    3
    Views
    94

    Just in case you do not have it the tech sheet...

    Just in case you do not have it the tech sheet for your unit is available below.
    https://drive.google.com/drive/folders/0BzIiBNwRIV4NNXdidFJ6SHRPVzg

    This is a difficult one since you have...
  25. As far as i know the only kit available is...

    As far as i know the only kit available is 5303918301. This is the Frigidaire part, you would have to do some jiggery pokery to fit/connect it in your unit.

    Another possibility would be to get a...
Results 1 to 25 of 493
Page 1 of 20 1 2 3 4