Search:

Type: Posts; User: denman

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    33

    Do you have the tech sheet. Often it is stored...

    Do you have the tech sheet.
    Often it is stored behind the kick plate.

    It would at least let yo check for error codes.

    I cannot tell what type of keyboard this unit has.
    Capacitive (touch)...
  2. Below is a service manual....

    Below is a service manual.
    https://drive.google.com/file/d/0BzIiBNwRIV4NazNtZjFSWHAxeHM/view

    Sounds like a control board problem but may also be a thermistor problem....
  3. Replies
    3
    Views
    33

    Sounds more like a control board problem . ...

    Sounds more like a control board problem .

    https://partsdr.com/part/w10595568-main-control-board
  4. Replies
    1
    Views
    32

    As far as I know the sensor should measure about...

    As far as I know the sensor should measure about 1100 ohms at room temperature.
    Double check that your meter is on the correct scale must be on the 2K or higher scale.
    Short your meter leads...
  5. Replies
    2
    Views
    105

    I cannot find a wiring diagram for this unit so...

    I cannot find a wiring diagram for this unit so am just guessing.

    It could be a grounded element.
    Check the heating coil.
    Unplug the unit and both wires to the element.
    Check it with a meter,...
  6. Do you have the wiring diagram. I cannot find...

    Do you have the wiring diagram.
    I cannot find one for this specific unit but have found info on a NE597 but am not sure how close a match it is.

    If the unit has the element control relays on the...
  7. Replies
    1
    Views
    94

    If the turntable is the type that rides on...

    If the turntable is the type that rides on plastic wheels check that they all turn easily.

    Yes it could be a bad replacement motor.

    The below assumes that this is a 120 volt AC motor.
    You...
  8. Yes it looks like the correct part.

    Yes it looks like the correct part.
  9. Replies
    1
    Views
    107

    This is best left to an electrician. Depends...

    This is best left to an electrician.

    Depends on the load etc.
  10. Then I would say that the replacement element is...

    Then I would say that the replacement element is also bad.
  11. Make sure you are on the correct resistance...

    Make sure you are on the correct resistance scale.
    The element should be about 72 ohms.

    If not you may have a bad replacement element.
  12. Replies
    1
    Views
    78

    You will need a lot more parts than just the...

    You will need a lot more parts than just the terminal block.

    Go mention just a few a main wiring harness, a timer. and a complete heater assembly etc. etc. etc.

    You will have to open a...
  13. Replies
    5
    Views
    293

    Remove the toe kick plate and the rear cover. ...

    Remove the toe kick plate and the rear cover.

    Is the condenser/compressor fan running.
    If the evaporator/freezer fan is on this fan should also be on.

    Check if the compressor is on.
    You can...
  14. Replies
    5
    Views
    293

    Do you have the wiring diagram.? Did you leave...

    Do you have the wiring diagram.?

    Did you leave the unit on for at least half an hour to see if it would start up?

    Did you turn the temperature control up and down (not to off) just to be sure...
  15. Replies
    5
    Views
    293

    Sorry but I cannot say which part is bad. You...

    Sorry but I cannot say which part is bad.
    You need to do more troubleshooting.

    I am assuming that by "now there is nothing" you mean that the compressor and both fans are off but the interior...
  16. Replies
    3
    Views
    77

    This is what I find very confusing. The water...

    This is what I find very confusing.
    The water comes in from the left side of the unit but as far as is pumped out of the sump in the center floor of the unit.
    So how can you hear water being pumped...
  17. Replies
    3
    Views
    77

    Below is a link to a manual. Although a different...

    Below is a link to a manual. Although a different model the pump system looks the same..
    You may have to join the site to download the manual....
  18. You might be able to get at the heater...

    You might be able to get at the heater connections by just removing the toe kick panel.

    It would not hurt to do the more extensive check on the thermistors.

    That Touch Up runs OK does seem to...
  19. First thing I would check is the heating coil. ...

    First thing I would check is the heating coil.

    Remove the wires from it and measure across it.
    It should be in the 8 to 12 ohm range.
    Then measure from each side of the element to the case, both...
  20. Replies
    2
    Views
    310

    Don't panic, give it some time. You may have...

    Don't panic, give it some time.
    You may have just gone into a defrost cycle.
    Both fans and the compressor will shut off.
    Defrost usually takes about half an hour.

    Do not leave the cover off for...
  21. I could not fin da manual for your unit but did...

    I could not fin da manual for your unit but did find one for a WT5070C unit.
    Looks basically the same as yours just a few extra options....
  22. A model number would be helpful. If I can find a...

    A model number would be helpful.
    If I can find a tech sheet for it, the sheet may have error codes etc.

    Unplugging it to fix it is often a case where you are resetting/clearing an error or often...
  23. Since it is a glass (capacitive) keypad before...

    Since it is a glass (capacitive) keypad before installing the boards open the door and let the area dry out.
    Also would be a good idea to disconnect connectors and clean them with electronics...
  24. Glad to hear that you are up and running. And...

    Glad to hear that you are up and running.

    And thanks for getting back to us. Now when others search for a similar problem they will see what actually worked instead of just suggestions about what...
  25. I cannot find any tech info on this unit....

    I cannot find any tech info on this unit.
    Hopefully you have the tech sheet.

    If the keypad is a normal bubble switch type pad then odds are that it is a control board problem.

    If the keypad is...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4