Search:

It looks to me like it is part of the main control board. See the part linked below.

Main Control Board - CSP30020904 (PD00087584)
https://media.partsdr.com/regular/L-GEBR78940613.jpg

Yes, the compressor is controlled by the control board on your model.


https://www.youtube.com/watch?v=dT0DTjktRUY

Is there any side to side play in the pump motor shaft? I would suspect that the pump motor might be failing.

See the two videos below. Hopefully these help you to troubleshoot the issue. Let me know what you find.

Locate tech sheet:

https://www.youtube.com/watch?v=Ens8pYh2K7U

Reset Calibration...

Great! Thank you for letting me know! I have updated this to FIXED.

I am referring to something different. If you turn off the water to the washer from the wall, and remove the hoses from the back of the washer and then turn them back on and spray the water into a...

Can you please test your heating element for a short using the instructions at 2:25 in the video below and let me know what you find? It would leave the dryer unplugged and stop using it until you...

That's too bad. Did you replace the part with a new GE part? Have you verified that the water supply from the house to the washer is good? Are you using washer fill hoses with a burst valve in...

Hi CMV, we have a note on this part on our website. It says this: This DC motor has an electrical plug with a 3 pin harness. If you need the DC motor with a 4 pin harness order part number...

The next thing I would do is a voltage test at the LED lights. Check a working light to see what the voltage should be for a working light. Then compare that against what the voltage is to the...

It's probably not part of the dishwasher.

The H2O Supply error code would indicate that water is not entering the washer. If the water supply to the washer is good, it is usually caused by a bad water inlet valve. The water inlet valve for...

That's too bad they sold you the wrong part. Let me know how it works once you get the correct LP conversion kit installed.

Yes, the Variable Speed Wash Motor they are referring to in the tech sheet would be the Circulation Pump Motor. Below is a link to the part.

I would also check the wiring from the pump motor to...

Thanks for sharing what you found! I have updated this to FIXED. Although re-soldering that spot on the control board will usually get it working, it isn't something that I would recommend doing as...

Does the dryer heat up on the air dry (no heat) cycle?

These are really tricky belts to install unless you have done them a few times. I am glad you got it figured out!

It looks like the LP Conversion Kit for your model that I linked below should have included orifices to convert the oven burners. Is this the part that you used to convert the range?

LP...

You would have to test the reed switch with a magnet to trigger the switch and a multimeter to test the switch for continuity.

https://www.youtube.com/watch?v=F76qOqyYOqY

Beside the main control board, it could also be a bad temperature sensor on the evaporator coil. See the videos below. Please note that a temp sensor can test good but still be bad. Let me know...

I would try replacing the thermistor on the evaporator coil next. Sometimes they can fail even if they test good. If it isn't that, then it would come down to the main control board or the wiring...

Hi C!

It sounds and looks to me like the motor is failing and on it's last leg. I would replace the motor before it does and you lose any food. Let me know what you find.

This is the motor...

Thank you. Let me know how it goes for you.

Can you please list the error code that you are receiving?

I can tell from your video that the gearcase is bad and leaking which is why you have all of the brown residue on the bottom. It looks to me like you will need to replace the gearcase. Let me know...