Results 1 to 2 of 2

Thread: whirlpool front load washer error code e1 and f6

  1. #1

    whirlpool front load washer error code e1 and f6

    Model Number: wfw9250wwo
    Brand: Whirlpool
    Age: 1-5 years

    Working on this unit tub will tumble only one way and very little and gets this error codes Could be mcu board?? Need service manual for repairs and any input will really help thanks guys and gals

  2. #2
    Admin/Technician Doc Ryan's Avatar
    Join Date
    Mar 2011
    Location
    South Dakota
    Posts
    4,230
    I have not seen a service manual for this washer yet. I have posted the information below about the error code and I also attached the tech sheet for this washer. Let me know what you end up finding.

    F6E1 - SERIAL COMMUNICATION ERROR

    The communication between the Central Control Unit (CCU) and the Motor Control Unit (MCU) cannot be sent correctly.

    Possible Causes/Procedure

    - Unplug washer or disconnect power.
    - Check that the power cord terminals are connected at the right position to the RFI filter (white-Neutral/ black-Line).
    - Check that the two ground switches are pressed correctly by the toe and rear panels.
    - Check that ground switches are fitted correctly, and are not broken and the green ground wires are connected correctly.
    - Make sure that both ground switches are not broken or scratched.
    - Make sure that all the ground harnesses (green wires) are connected correctly, and are not broken or with wires detached.
    - Make sure that all wire harness connections from the CCU (MI3 cavity), main Motor, and MCU are not broken or with wires detached, and that connector internal pins are visible.
    - Check for continuity from the MCU connector wires to CCU (MI3 cavity) connector.
    - If the continuity diagnosis failed, the Main Harness must be replaced.
    - Make sure that all the connectors are fully seated.
    - Check the drive system for any worn or failed components.
    - Plug in washer or reconnect power.
    - Verify the washer operation by running the Diagnostic Test cycle. See page 5.
    - After the diagnostic test has finished, unplug washer or disconnect power and wait for 15 seconds.
    Attached Files Attached Files
    Ryan

    PartsDr.com
    - Discount Appliance Parts & Accessories


    Please help keep our repair forum FREE by purchasing your replacement parts from our online store. Thank you for your support.

    Check out our Repair Videos on Youtube

    "Like" Parts Dr on Facebook


    Follow Parts Dr on Twitter

Similar Threads

  1. Frigidaire Washer E47 Error Code
    By Doc Ryan in forum Washer Repair
    Replies: 2
    Last Post: 12-14-2018, 09:54 AM
  2. GE Front Load Washer Leaks on Fill
    By TheStorm in forum Washer Repair
    Replies: 2
    Last Post: 03-30-2014, 06:39 PM
  3. maytag bravos washer sd error code
    By gregaguilar in forum Washer Repair
    Replies: 1
    Last Post: 06-11-2013, 11:09 AM
  4. Replies: 1
    Last Post: 02-08-2013, 09:44 PM
  5. LG Washer Won't Spin, Error Code CE
    By alikat95 in forum Washer Repair
    Replies: 3
    Last Post: 10-23-2012, 09:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •