Model Number:
Brand: Maytag
Age: 1-5 years
Washer beeps before going into spin cycle and ND showing on the screen. I know from previous posts it means Not Draining, I removed the back panel, removed the pump, cleaned all of it and installed everything again, this time forgetting!!! to plug the electrical harness into the pump. Turn on the washer and it went into rinse cycle. A minute later I recalled I did not hook up the wire, I stopped it and reconnected the wire to the pump. Turned on the washer and it showed ND again and that was it. Is it the pump or the control module?
P.S. Hoses are clean, took the pump apart and did not find anything inside of it.