Model Number: GHW9400PT0
Brand: Whirlpool
Age: 6-10 years
Hi There,
I ordered the a replacement water inlet valve and in the process of replacing it I cracked the dispenser housing - part #http://www.partsdr.com/Parts/280198-Dispenser-25602.cfm
Can you provide directions on how to replace the dispenser housing?
I've removed the water hoses secured by clamps, and the dispenser motor, but i can't seem to reach the last screw that attaches the dispenser housing to the front of the washer. The top of the screw is be hid the control panel on front of the washer, which I cant' figure out how to remove.
Also it might be helpful to note on forums that torx screwdriver heads are required. Also in replacing a water inlet valve one should be very careful not to break the dispenser housing - ha!
Thanks!