Model Number: 417.44152400
Brand: Sears Kenmore
Age: More than 10 years
Hi all. I would like to know how to approach troubleshooting my issue if you can't get an error code. My understanding is you follow this procedure which I found online elsewhere. I received help from Jake's forum if anyone here is familiar with him. I was told:
Wake the machine by pressing any button
• Wait 5 seconds
• Press and hold the Start and Pause Cancel buttons simultaneously
• All LEDs will go blank and after a few seconds the control will signal the stored code using audible beeps and blinking LEDs. The control will repeatedly signal the code, as long as the Start and Pause Cancel buttons are pressed. A two-second pause between repeats affords you the ability to make accurate counts to identify the correct error codes.
This worked before, but now I wake the machine and I see the lights on as attached, but the light above the start button is flashing. I hold down start and pause/cancel I get 3 beeps, but nothing with the lights change. If I press the start button I get 3 beeps and the light above the start button flashes 3 times. If I push the cancel button I get 3 beeps and the five lights on the right flash 3 times. Not sure that means anything, just grasping at straws. Then the same lights stay lit and the one light continues to flash. Any help on what to do next would be appreciated. Thanks.