gas dryer help Whirlpool Cabrio

[Michelle Hawk Mattox]

Model Number: wgd6200sw1
Brand: Whirlpool
Age: 6-10 years

I am getting F1 error code. I have replaced the control board with a new one and still getting the same code. Dryer turns on, drum spins. Not staying hot or sensing that the clothes are wet. I have checked the fuse ( seems fine) and replaced moisture sensor as well. The trap is clean and so is vent. Any thoughts as to what could be wrong? Is there a re-set to re program the new board or should it just be a plug in and go? Advance thanks for any words of wisdom to help with troubleshooting.

[Doc Ryan]

The new board should be able to plug in and be ready to use. It sounds like the new part is most likely defective.