Model Number: DV45H7000E
Brand: Samsung
Age: Less than 1 year

My dryer is less than 6 months old. I've tried going through Samsung warranty repair and have decided it would probably be easier trying to fix this myself. My dryer wont heat. Airflow is good, no lint build up. Source Voltage is 240v. There is continuity through the heat element, high limit switch, and thermal cutoff. 2 wires going to heat element (Red & Blue), the Red has 120v but the blue is dead. Up top behind the controls is the power board. (?) There is 120v on the line side (Black). When the dryer is turned on i get 120v through the relay to the Blue wire. Also, i checked for continuity from the leads of the element to chassis ground, and there is none. (just to make sure the element wasn't broke and laying against the housing. So, i have 120V on the blue wire leaving the relay but not on the blue wire going to the heat element. Am i supposed to have 240V between both leads going to the heat element? Any help would GREATLY appreciated as the wife is all over my back