Model Number: PDW9880N20SS
Brand: GE
Age: 1-5 years
I recently had issues with my GE not finishing a cycle. I would have to run a cycle over and over to get it to even drain. I replaced the control module from the information I learned reading this Forum. Now the dishwasher runs through a cycle without a problem, even fixed a problem with my display that I didn't think it would (some of the lights that make up the numbers on the display were not illuminating). But now I have three functions that no longer work, heated dry, extra heat and pre-wash. I can maneuver through all the cycles, the delayed start works, the start reset button works fine, just no extra heat, pre-wash or heated dry. The heated dry button also acts as a panel lock if held for three seconds and that does not work either. All of these functions worked before and are not now.
My dishwasher is a GE PDW9880N20SS. I replaced the control module with part number WD21X10367 which I was told was the new updated part for my dishwasher. I have checked all the connections and they seem to be good. Please Help!!!