Results 1 to 1 of 1

Thread: Cabrio Washer still leaking after seal and pump has been replaced

  1. #1

    Cabrio Washer still leaking after seal and pump has been replaced

    Model Number: wtw5840bw0
    Brand: Whirlpool
    Age: 1-5 years

    I have Cabrio washer that has a pretty massive leak coming out of it. It takes about 2 or 3 towels to clean it up after each load. First thing I did was change seals as generally suggested. That didn't change anything. It almost seem like it made it worse actually. I then went and changed the pump and still nothing. I also lowered water pressure, as it was a common suggestion. I raised the washing machine to observe the leak and it looks like it is coming out of the sides of the transmission case. But not down the middle where I assume a leak would be if it was a seal. Is it possible that it is something else, or the new tub seal was bad? When I installed the tub seal, I did not take the drum out like the videos suggested and realized that when putting the transmission back on it makes the alignment off, or harder to get right. I took it apart this time without the tub and it seems better but still leaking. Is there anything I am missing or over looking? I didnt change the bearings or shaft.
    Last edited by stinkoman; 11-10-2017 at 10:55 AM.

Similar Threads

  1. Replies: 5
    Last Post: 07-06-2016, 05:21 PM
  2. Replies: 2
    Last Post: 07-06-2015, 07:02 PM
  3. code nd replaced drain pump
    By Silverfox in forum Washer Repair
    Replies: 2
    Last Post: 11-19-2014, 08:59 PM
  4. Replies: 7
    Last Post: 11-11-2014, 08:22 PM
  5. Money in drain pump of Whirlpool Cabrio
    By paubiejohn in forum Washer Repair
    Replies: 1
    Last Post: 08-09-2013, 03:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •