Results 1 to 2 of 2

Thread: HELP! How do I configure jumper on new control board?

  1. #1

    HELP! How do I configure jumper on new control board?

    Model Number: CDT765SSF7SS
    Brand: Brand
    Age: 1-5 years

    Hello,

    I bought a replacement control board for my GE Cafe Dishwasher CDT765SSF7SS. The control board number is WD21X23459.

    It came with instructions that say to configure personality jumpers before installing. I see the appropriate configuration listed and I see the jumper on the board. This might be a stupid question, but how do I actually configure it? Do I push those copper tabs? Do I need a special tool?

    Thanks in advance!
    Attached Thumbnails Attached Thumbnails Board 1.jpg   Board 2.jpg   Board 3.jpg   Board 4.jpg   Board 5.jpg  


  2. #2
    Doc
    Join Date
    Mar 2016
    Posts
    709
    There should be small jumpers, that are used to short between the pins.
    You take them off the old board and place them in the same position on the new one.

    If there are no jumpers on the old board then you do not need them.

Similar Threads

  1. HV control board programming
    By dlcottrell in forum Refrigerator or Freezer Repair
    Replies: 0
    Last Post: 02-10-2018, 01:43 PM
  2. Which control board do I replace?
    By Skyemom in forum Washer Repair
    Replies: 1
    Last Post: 10-28-2015, 08:48 PM
  3. GE replaced main control board, temperature control not working
    By Kcnsfryer in forum Refrigerator or Freezer Repair
    Replies: 5
    Last Post: 01-27-2015, 11:46 AM
  4. Replace control panel/touchpad or control board?
    By Grayrider in forum Dishwasher Repair
    Replies: 1
    Last Post: 09-05-2013, 12:04 PM
  5. Do I need a new control board
    By bums in forum Dryer Repair
    Replies: 1
    Last Post: 04-24-2013, 08:23 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •