Results 1 to 2 of 2

Thread: Jen Air Wall Oven control clock doesn't go on

  1. #1
    Patient
    Join Date
    Jan 2019
    Location
    Escanaba
    Posts
    1

    Jen Air Wall Oven control clock doesn't go on

    Model Number: JJW9530BAB
    Brand: Jenn-Air
    Age: More than 10 years

    I pull my Jen air wall oven out to install an induction stove top. Before I reinstalled it, I checked to see if the power was going to the wall oven. After the clock went on, I turned the breaker off and then installed the oven back into the wall. When I turned it on, the unit did not go on. No display. I had it wired wrong, I didn't have it wired 220, so then I wired it the correct way and it still does not come on. I think I need a new control panel, but not sure. Is there a way to test what went wrong? Any suggestions?

  2. #2
    Below is a link to a service manual "16010312 Jenn-Air Elect..." which includes this unit.
    https://drive.google.com/drive/folde...kozZ1AzbDFtZ1E

    All I can suggest is that you double check your wiring.

    I doubt that it is a control panel problem.
    More likely a control board (display board) or a relay board problem.

    If you have a meter then you could check if the correct voltage is going to the control board.
    The wiring diagrams are on page 4-13 and 4-14.
    To say the least they are rudimentary so have to be used with the wiring listing info.

    The relay board is no longer available and it is the most likely suspect.

Similar Threads

  1. Replaced GE wall oven and now No Lights No Clock No Power
    By gastonlv in forum Range, Oven, & Cooktop Repairs
    Replies: 6
    Last Post: 09-21-2018, 12:30 PM
  2. Jenn Air clock/control failure
    By bobdabuilder in forum Range, Oven, & Cooktop Repairs
    Replies: 0
    Last Post: 08-14-2018, 06:14 PM
  3. Replaced the clock /control module today but the oven still will not heat
    By Bro_Ed in forum Range, Oven, & Cooktop Repairs
    Replies: 3
    Last Post: 10-11-2013, 01:48 PM
  4. Replies: 3
    Last Post: 05-19-2013, 09:13 PM
  5. Do I need a new control/clock panel
    By brandy77 in forum Range, Oven, & Cooktop Repairs
    Replies: 3
    Last Post: 10-14-2011, 11:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •