Model Number: 91130168894
Brand: Brand
Age: Less than 1 year
Model Number: 91130168894
Brand: Sears Kenmore
Age: More than 10 years
Hi All,
I'm trying to fix grandma's wall oven that hasn't worked in I don't know how long.
The Control Panel works great - all buttons and functions seemed to be working fine, but the igniter never came on. So i replaced it.
Oven still won't heat. So i decided to tear it apart and try to track down the problem.
I took the Control Panel off and found the Schematic/Diagram paper and followed the testing as outlined and the panel is putting out the correct voltage to the igniter
I tested the thermostat and the ohms were in line at both the thermostat and from the control panel thorugh the wiring (1083 measured vs 1100 expected at room temperature)
Just for a sanity check i tested the igniter by attaching it to a known 120 V source and it lights up just fine
Here is where i'm stumped:
The voltage when i turn the oven/broiler on is 20 measured at the two leads that connect to the igniter
I can get 120 V from one of the leads when i touch ground and only a few volts on the other wire
I did a continuity test on the safety valve and didn't get anything
I do have gas going to the actual gas valve
I'm thinking its the safety valve, but not sure.
Any help would be great.
Here are pics of the schematic below