Model Number: EWMED70JMB0
Brand: Electrolux
Age: 6-10 years
Lightening strike / power surge took out control board, display flickering. UI control knob LEDs not working prior. Replaced both items with current revisions.
Control board - #809160302NH, purchased at partsdr.com.
UI - #809160410, purchased locally.
Power up and attempt to run "installation cycle", when I press start nothing happens, well the UI beeps acknowledging start pushed but that's all.
120vac at, J2-3, J2-4, J3-2, J5-1, J5-3, J7-2.
E91 randomly shows when I check for error codes but never shows on the operator screen. I can clear it, check again after attempting the installation cycle and no code.
DIAGNOSTIC MODE, all functions work as they should, motor runs both directions, elements heat and I can see the temp rise. If all functions work in "diagnostic mode" then why does it not start the installation cycle?
Assistance appreciated before I send this thing to death row! And my wife cringes at the thought of mismatched appliances.