Results 1 to 2 of 2

Thread: Agitator not sitting all the way down.

  1. #1

    Agitator not sitting all the way down.

    Model Number: MVWB450WQ2
    Brand: Maytag
    Age: 6-10 years

    After replacing bearing and seal the agitator wont sit properly. The shaft is completely in. I also measured the old shaft and new and they are the same length. Any help will be appreciated. Thanks
    Attached Thumbnails Attached Thumbnails 20191112_204948.jpg   20191112_205012.jpg   20191112_210339.jpg  
    Last edited by Kenuel80; 11-13-2019 at 05:38 AM.

  2. #2
    As you can see from the last picture the shaft is all the way down, isn't it?

Similar Threads

  1. Replies: 248
    Last Post: 10-05-2023, 11:39 AM
  2. removing stuck agitator inner cap seal
    By BillC in forum Washer Repair
    Replies: 0
    Last Post: 05-17-2019, 12:28 PM
  3. Agitator snags clother
    By Daytona in forum Washer Repair
    Replies: 2
    Last Post: 11-16-2018, 04:31 PM
  4. Maytag top load agitator locks up after spin cycle
    By jasper07481 in forum Washer Repair
    Replies: 1
    Last Post: 07-31-2014, 12:03 PM
  5. Whirlpool Duet - water in tub after sitting
    By lspurgin in forum Washer Repair
    Replies: 1
    Last Post: 12-18-2013, 11:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •