Results 1 to 4 of 4

Thread: Whirlpool Cabrio spins but doesnít agitate - tried everything

  1. #1

    Whirlpool Cabrio spins but doesnít agitate - tried everything

    Model Number: WTW5600XW3
    Brand: Whirlpool
    Age: 6-10 years

    Hello - My Whirlpool washer is working fine but doesnít agitate. Iíve tried replacing both the actuator and the control board but the same thing happened. Everything is fine until the wash cycle when it makes very short noises, almost sounds like a buzzer going off repeatedly every few seconds. Then it goes into rinse and spin and works fine. Itís only the wash cycle where it seems not to be agitating. Any ideas would be greatly appreciated.

  2. #2
    Join Date
    Jun 2021
    On the off chance that your Whirlpool washer will not unsettle however will turn, you may have to supplant the maintenance pack. The washer fomenter fix unit houses the instigator segments that are destined to get harmed, wear out, or come up short. In the event that any of the parts are exhausted, stripped, or imperfect in any capacity, at that point it's an ideal opportunity to supplant the unit.

  3. #3
    Many thanks. Is this the maintenance pack that I would need to replace?

  4. #4
    I’m also having the same problem with my Whirlpool. I replaced the actuator and the splutch/clutch assembly. When agitating, it just clicks.

Similar Threads

  1. Whirlpool Cabrio Help
    By Branderson024 in forum Washer Repair
    Replies: 1
    Last Post: 06-25-2020, 02:52 PM
  2. Replies: 0
    Last Post: 11-13-2019, 04:54 AM
  3. whirlpool top load washer won't fill, still spins
    By haatstuff in forum Washer Repair
    Replies: 1
    Last Post: 08-09-2016, 05:49 PM
  4. Replies: 6
    Last Post: 06-24-2013, 08:58 PM
  5. Whirlpool Cabrio
    By caepperson3 in forum Dryer Repair
    Replies: 8
    Last Post: 06-21-2013, 01:41 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts