Results 1 to 2 of 2

Thread: Cannot Program after module install

  1. #1

    Cannot Program after module install

    Model Number: Whirlpool GI5FSAXVY02
    Brand: Whirlpool
    Age: 1-5 years

    Had a service tech diagnois a no cooling problem. He said the motherboard was bad and would cost over $300.00 for the part, but the part was on back order until January. I oredered the part (W10310240) online for $130.00 and it arrived 3 days later. I installed the part, but cannot program the unit. The display Program Code reads P0000, but I cannot change it. if I press the refrigator up and down arrows it changes from ice to water. None of the other buttons seem to work.
    I followed the instructions to enter program mode but it is not allowing me to make any changes. The tech said the module in the door was good. Any ideas?

  2. #2
    Admin/Technician Doc Ryan's Avatar
    Join Date
    Mar 2011
    Location
    South Dakota
    Posts
    4,230
    Did you follow the instructions from this post here?
    Ryan

    PartsDr.com
    - Discount Appliance Parts & Accessories


    Please help keep our repair forum FREE by purchasing your replacement parts from our online store. Thank you for your support.

    Check out our Repair Videos on Youtube

    "Like" Parts Dr on Facebook


    Follow Parts Dr on Twitter

Similar Threads

  1. Bottom mount frost kit #12002754 install instructions
    By sharkf in forum Refrigerator or Freezer Repair
    Replies: 5
    Last Post: 09-01-2012, 09:26 AM
  2. How to install control board 12868513
    By REPAIRMANDAN in forum Refrigerator or Freezer Repair
    Replies: 5
    Last Post: 02-16-2012, 12:15 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •