Search:

Thanks for following up. I will update this to FIXED for now.

Below is a link to the drive motor for this model dryer and a video on how to replace the motor.

Drive Motor - DC31-00055G...

Thank you for sharing the fix for the problem! I am glad that you got it fixed.

It's hard to know what normal run time is in your use case. My guess is that it is working normally. I don't think replacing parts is going to change anything.

I don't think a service manual exists for this range currently. I don't have the answer to your question either. Hopefully someone else can chime in and answer your question. If you figure it out,...

Hi Don,

The wax motor on the vent assembly should measure 600-1800 ohms. That value is too high to register on a continuity test, you will need to have your multimeter set to measure ohms to test...

Did you turn on delay start by accident? Try pressing and holding the START/CANCEL button for 3 seconds to cancel the delay start option.

Did you replace the main control board or the user...

This freezer uses the control board and a temperature sensor (thermistor) to control when the freezer runs to cool down. It should run until it reaches the set temperature and a little below, then...

The "after" photo looks perfect. That is good!

When you put it back together and let it run for 24 hours, what is the temperature inside if you measure it with a thermometer?

What indicates to...

I think that would narrow it down to a few things.

1. Power supply to the dryer. Check to make sure you have 220/240V to the dryer. Also, check the terminal block where the power cord attaches...

Can you unplug it, take it apart again, then plug it in and let it run for 15-20 minutes? After that take a picture of the evaporator coil and post it here.

How old is it?

I agree that it sounds like you most likely have a bad control board. These types of problems can be almost impossible to troubleshoot as Samsung usually does not provide enough information to be...

Let me know how it goes!

It is in the rear of the freezer, #16 in the attached diagram below. The evaporator coil will be obvious once you have this cover removed.

(Click to enlarge)
1345

Can you post some pictures of what you are dealing with?

It looks like your defrost drain is frozen. To fix this you will need to unplug the refrigerator and then remove the rear evaporator cover. With the cover removed pour warm water on the ice at the...

Great! Thanks for the udpate!

The overlay can be re-used as long as it peels off in once piece. Often times because they have been stuck on there for so long they will start to come apart when you try to peel it off. You can...

DA96-00640B is back in stock on our site right now.

Usually, the washer will have an error code relating to not draining. It is strange that you are not receiving any error codes.

Sounds good, let me know what you find.

Have you checked to see if power is being sent to the drain pump when it should be draining? If the main control board is not sending power to the drain pump, that could cause the washer to not...

See the two parts below. You need to order quantity 2 of the end cap.

Door Shelf Trim - WPW10421486 (PD00004873)
https://media.partsdr.com/regular/WPLW10421486.jpg

Shelf Trim End Cap -...

My guess is that the control board that sends power to the heating elements has failed. Before replacing the control board you could verfiy that there are not any burned or broken wires and that the...

It sounds like one of the relays that sends power to the heating element on the control board is bad. That is the only thing that I know of that could cause these types of symptoms. Let me know...