GE front load washer h2o supply error code

[Fitzwell]

Model Number: Gfw850spn0rs
Brand: GE
Age: 1-5 years

GE washer starts washing then gives h20 supply error code before finishing cycle.

[Doc Ryan]

Can you please list the error code that you are receiving?

[Fitzwell]

Washer screen says h2o supply.

[Doc Ryan]

The H2O Supply error code would indicate that water is not entering the washer. If the water supply to the washer is good, it is usually caused by a bad water inlet valve. The water inlet valve for this model washer has multiple solenoids on it that are electronically controlled to open and close, which control the water flow into the washer. If one of these solenoids fails, the washer will not fill with water when it is supposed to and the washer will display the H2O Supply error. Let me know what you find.

This is the water inlet valve for your model washer here:

Water Inlet Valve - WH23X29553 (PD00067381)

[Fitzwell]

Yes that's what I thought as well. Replaced water inlet valve and still same outcome.

[Doc Ryan]

That's too bad. Did you replace the part with a new GE part? Have you verified that the water supply from the house to the washer is good? Are you using washer fill hoses with a burst valve in them?

[Fitzwell]

Yes we have braided stainless steel hose on them.

[Doc Ryan]

I am referring to something different. If you turn off the water to the washer from the wall, and remove the hoses from the back of the washer and then turn them back on and spray the water into a bucket, do you have good water flow?

[Doc Ryan]

Did you ever find the solution to your problem?